RTM PWH_F2_2025JAN08_R2

Core/Inc/sys_conf.h

@@ -47,12 +47,12 @@ extern "C" {
 /**
   * @brief  Verbose level for all trace logs
   */
-#define VERBOSE_LEVEL                        VLEVEL_L
+#define VERBOSE_LEVEL                        VLEVEL_OFF
 
 /**
   * @brief Enable trace logs
   */
-#define APP_LOG_ENABLED                      1
+#define APP_LOG_ENABLED                      0
 
 /**
   * @brief Activate monitoring (probes) of some internal RF signals for debug purpose
@@ -75,7 +75,7 @@ extern "C" {
   * @brief Enable/Disable MCU Debugger pins (dbg serial wires)
   * @note  by HW serial wires are ON by default, need to put them OFF to save power
   */
-#define DEBUGGER_ENABLED                     1
+#define DEBUGGER_ENABLED                     0
 
 /**
   * @brief Disable Low Power mode

STS/Core/Inc/yunhorn_sts_prd_conf.h

@@ -185,9 +185,9 @@
 #define sts_appctrl_reply_port					(YUNHORN_STS_USER_APP_CTRL_REPLY_PORT)
 
  /*		General Settings							*/
-#define MajorVer									24U
-#define MinorVer									11U
-#define SubMinorVer 								27U
+#define MajorVer									25U
+#define MinorVer									1U
+#define SubMinorVer 								8U
 #define FirmwareVersion								3U
 #define	YUNHORN_STS_MAX_NVM_CFG_SIZE				64U
 #define YUNHORN_STS_AC_CODE_SIZE					20U

STS/TOF/App/app_tof.c

@@ -645,7 +645,7 @@ static void print_result(RANGING_SENSOR_Result_t *Result)
 
   head_height_level_from_floor = MIN(1400, abs(sts_sensor_install_height - head_distance_from_ceiling));
 
-  APP_LOG(TS_OFF, VLEVEL_L, "\r\n Raw Head height=%d cm Calculated head level=%d cm\r\n", head_distance_from_ceiling/10, head_height_level_from_floor/10);
+  APP_LOG(TS_OFF, VLEVEL_L, "\r\n Updown distance=%d cm, Floor Up head =%d cm\r\n", head_distance_from_ceiling/10, head_height_level_from_floor/10);
 
   /* state tree */