--- rtm ATAL 2024DEC31

Core/Inc/sys_conf.h

@@ -47,12 +47,12 @@ extern "C" {
 /**
   * @brief  Verbose level for all trace logs
   */
-#define VERBOSE_LEVEL                        VLEVEL_M
+#define VERBOSE_LEVEL                        VLEVEL_OFF
 
 /**
   * @brief Enable trace logs
   */
-#define APP_LOG_ENABLED                      1
+#define APP_LOG_ENABLED                      0
 
 /**
   * @brief Activate monitoring (probes) of some internal RF signals for debug purpose
@@ -75,7 +75,7 @@ extern "C" {
   * @brief Enable/Disable MCU Debugger pins (dbg serial wires)
   * @note  by HW serial wires are ON by default, need to put them OFF to save power
   */
-#define DEBUGGER_ENABLED                     1
+#define DEBUGGER_ENABLED                     0
 
 /**
   * @brief Disable Low Power mode

LoRaWAN/App/lora_app.c

@@ -656,9 +656,9 @@ void HAL_GPIO_EXTI_Callback(uint16_t GPIO_Pin)
 #ifdef STS_T6
     case  PIR_Pin:
     	sts_pir_state= PIR_STATE;
-    	  HAL_Delay(100);
+    	  // HAL_Delay(50);
     	  __HAL_GPIO_EXTI_CLEAR_IT(GPIO_Pin);
-    	  APP_LOG(TS_OFF, VLEVEL_M, "\r\nMotion Detection result=%d \r\n", sts_pir_state);
+    	// APP_LOG(TS_OFF, VLEVEL_M, "\r\nMotion Detection result=%d \r\n", sts_pir_state);
     	// UTIL_SEQ_SetTask((1 << CFG_SEQ_Task_LoRaSendOnTxTimerOrButtonEvent), CFG_SEQ_Prio_0);
 
       break;